View source for InteractiveTechnologies CueServer-Pro-CS-800

[[Category: Automation]] [[Category: hardware]] 
[[Category: GSD]]
This is a template for a DMX lighting controller by Interactive technologies - model [http://www.interactive-online.com/products/cueserver/overview Cueserver pro800]
Its very basic at the moment however it is working using the serial port I have followed the guide in the wiki "Implementing Clipsal Interface using Generic Serial Device"also adding in device data #76 COM Port ParityBit/Stop(string) #78 COM Port BaudRate(string)

in the RUBY CODE under "Ruby Internal Commands"-"#384 Process Receive Command For Child "add 

 id=device_.childdevices_[cmd.devidto_].devdata_[12]#get child device number
 if cmd.id_==192 #192 is on
   conn_.Send("[c"+id+"atfl]\r") #set id to full
 end
 if cmd.id_==193 #193 is off
   conn_.Send("[c"+id+"rel]\r") #relase id to zero
 end
 if cmd.id_==184 #184 dimmer
   conn_.Send("[c"+id+"at50]\r") #set id to 50% it should step the light up or down this is not working at present
 end

== Things To Do ==
* get #184 the dimmer command to work correctly
* add log/messages to keep lmce up to date
* intergrate the 8 contact closures on the cueserver this could work as alarm interface
* get it to work over the ethernet write a driver in c++