View source for Merten 5072xx Connect Radio Push Button 4gang

[[Category: Hardware]]
[[Category: Automation]]
[[Category: Lighting]]
[[Category: ZWave]]
[[Category: ZWave_wall_switch]]
{{versioninfo}}
[[Image:Connect505219.jpg|thumb|200px|Merten 5072xx]]

= Status =
Working

= About =
The Merten 5072xx is a 2-surface, 4-gang Z-Wave battery powered remote controller that can be screwed or stuck to a surface.

= Features =
* dual surface, 4-gang
* special door bell mode (not yet tested)

= Device setup =
Device type: Controller
== Inclusion/Exclusion/Node Info Frame ==
* triple click on connected switch

== Input setup ==
<table border="1"><th>Button</th><th>Association Group</th><th>Parameter no</th>
<tr><td>Top Left</td><td>1</td><td>0</td></tr>
<tr><td>Bottom Left</td><td>2</td><td>1</td></tr>
<tr><td>Top Right</td><td>3</td><td>2</td></tr>
<tr><td>Bottom Right</td><td>4</td><td>3</td></tr>
</table>

== Parameter values ==
<table border="1"><th>Function</th><th>Value</th>
<tr><td>
Switching/Dimming/Shutters
</td><td>
0
</td></tr>
<tr><td>
Switching single-surface
</td><td>
4
</td></tr>
<tr><td>
Retrieve scene
</td><td>
60
</td></tr>
<tr><td>
Doorbell function
</td><td>
44
</td></tr>
<tr><td>
Move shutter single surface (changes direction each press)
</td><td>
54
</td></tr>
<tr><td>
Lower shutter as long as button is pressed
</td><td>
52
</td></tr>
<tr><td>
Raise shutter as long as button is pressed
</td><td>
55
</td></tr>

</table>
== Factory reset ==
* Press button 3 times within 1.5 seconds. The LED will flash.
* Press and hold the button for about 5 seconds until the LED turns off.

= Links =
http://www.merten.de/download