View source for Tricklestar 200ZW-EU-W

[[Category: Hardware]]
{{versioninfo|710Status=According to category, Works without caveats|710UpdatedDate=11th May 2010|710UpdatedBy=[[User:Wierdbeard65|Wierdbeard65]]|810Status=According to category, Works without caveats|810UpdatedDate=11th May 2010|810UpdatedBy=[[User:Wierdbeard65|Wierdbeard65]]|}}
[[Category: RF Control]]
[[Category: ZWave]]
[[Category: ZWave_remote]]
[[Category: Works without caveats on 0710]]
[[Category: Works without caveats on 0810]]
[[Image:200ZW-XX-W-ii-(HI-RES).jpg|thumb|200px|Tricklestar 200ZW-EU-W]]

= Status =
Tested with the latest svn Z-Wave driver (will be included in 0810). Also works as inclusion controller when LinuxMCE runs as SIS.
Runs also fine with stock 0710 as primary or secondary controller.

'''This is a recommended inclusion controller'''

= About = 
The Tricklestar 200ZW-EU-W is a Z-Wave Remote Controller based on a Zensys chip. It uses a frequency of 868MHz. There is also a US version.

= Configuration Switch =
The product has a slide switch under the Rubber end piece (next to the USB connector), which can set the product in “Operation Mode” and “Configuration Mode”.

= How to reset the Remote (from the Manual) =

Resetting the Controller
# Put the Configuration Switch in “Configuration Mode”.
# Press-and-hold “Up” Operation button for 2 seconds to enter Configuration Mode. LED Indicator will illuminate Green.
# Press-and-hold “Up” Operation button for 10 seconds - this will initiate a reset of the Controller. LED Indicator will alternate Red, Yellow and Green while remote is being reset.
# LED Indicator on the Remote will illuminate Green when Reset is successfully completed and illuminate Red if the operation is unsuccessful.

= Links =
http://www.tricklestar.com