Difference between revisions of "Medion MD1 NBC"
From LinuxMCE
m |
Wierdbeard65 (Talk | contribs) m |
||
| Line 1: | Line 1: | ||
| + | {{versioninfo}} | ||
[[Category: Input]] | [[Category: Input]] | ||
[[Category: Supported]] | [[Category: Supported]] | ||
Revision as of 19:18, 3 May 2010
| Version | Status | Date Updated | Updated By |
|---|---|---|---|
| 710 | Unknown | N/A | N/A |
| 810 | Unknown | N/A | N/A |
| 1004 | Unknown | N/A | N/A |
| 1204 | Unknown | N/A | N/A |
| 1404 | Unknown | N/A | N/A |
| Usage Information | |||
Medion MD1 NBC
Medion MD1 NBC (Made in China by X10) is a RF Remote Controler.
It has all (almost) what you need to control your LinuxMCE. It uses 2 x 1.5V AAA batteries.
- P/N: 20018268
- FCC ID: B4S20018268
I`ve got it along with KNC ONE TV-Station DVR analog tv tuner card.
X10 Receiver
The X10 RF receiver need to be connected directly into the mainboard USB pin.
- P/N: 20018267
Technical Specification:
It has CE mark so it is approved for use in the EU.
- RF Frequency: 433 MHz
- Operating range: 30m or 60feet (open field)
- Can support up to 16 remotes
- Works through walls using RF technology even when not aimed at the receiver
Setup
The device works with LMCE using LIRC. I`ve configured my device using Add_support_for_new_remote_controls guide.
Note:LinuxMCE will automatically load ati_remote kernel module which doesn`t seem to work. You need to prevent doing this by either doing
echo "blacklist ati_remote" >>/etc/modprobe.d/blacklist
as root or deleting the module.
My lircd.conf.
