Difference between revisions of "HarmanKardon AVR245"
From LinuxMCE
| Line 1: | Line 1: | ||
| − | [[Category: | + | [[Category: Hardware]] |
| − | + | ||
| − | + | ||
[[Category: Audio]] | [[Category: Audio]] | ||
{{versioninfo}} | {{versioninfo}} | ||
Revision as of 15:32, 28 September 2010
| Version | Status | Date Updated | Updated By |
|---|---|---|---|
| 710 | Unknown | N/A | N/A |
| 810 | Unknown | N/A | N/A |
| 1004 | Unknown | N/A | N/A |
| 1204 | Unknown | N/A | N/A |
| 1404 | Unknown | N/A | N/A |
| Usage Information | |||
| This article is a stub and requires expansion |
- 2 x HDMI-in to HDMI-out (selectable)
- OSD setup
- hard power-switch (in/out toggle) next to soft power switch (push button)
- RS232 port on rear is only for firmware upgrades, according to manual, however there is an external IR input jack, so external control via PC will just require a little more "glue"
- dim/night mode for display, which dims the VFD, and shuts off the inner blue glow of the volume control
- There is an A/V Delay setting, which can be used to add latency to the audio in order to sync with other audio output devices. I noticed that my LG 42LB5D has a bit of audio latency on its speakers, and until I figure out how to eliminate it, I have set my AVR245 to 80ms of delay, which syncs it up nicely with the TV.
