Difference between revisions of "How to setup Samba with two workgroups?"
From LinuxMCE
Jerry finn (Talk | contribs) |
|||
| Line 1: | Line 1: | ||
| − | <table width="100%"> <tr><td bgcolor="#FFCFCF">This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007. In general any information should apply to LinuxMCE. However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto.</td></tr> </table>I have | + | <table width="100%"> <tr><td bgcolor="#FFCFCF">This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007. In general any information should apply to LinuxMCE. However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto.</td></tr> </table>I have LinuxMCE hybrid in "LinuxMCE" workgroup. I have the rest of my windows computers on another workgroup. They seem not to see each other unless I do this : |
# add | # add | ||
wins support = yes | wins support = yes | ||
Revision as of 14:06, 15 March 2007
| This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007. In general any information should apply to LinuxMCE. However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto. |
- add
wins support = yes
under [global] section in /etc/samba/smb.conf - it's even better if you change this in /usr/pluto/templates/smb.conf.tmpl
- add Hybrid's IP as Wins server on all windows clients....
