Difference between revisions of "Lights"

From LinuxMCE
Jump to: navigation, search
Line 1: Line 1:
−
<table width="100%"> <tr><td bgcolor="#FFCFCF">This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007.  In general any information should apply to LinuxMCE.  However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto.</td></tr> </table><p>Here you will add all the lights in your home.  Note by lights we mean the actual light switches--not the lighting control system.  The lighting control system (Lutron, Vantage, X10, etc.) is added on the interface page first.  Then you add the actual lights here.  You can have a mix of systems (Lutron and X10, for example).  For whatever interfaces you added, you will be able to add the lights here.  Blinds, drapes and motorized shutters are also treated as lights.</p>
+
Here you will add all the lights in your home.  Note by lights we mean the actual light switches--not the lighting control system.  The lighting control system ([[Lutron]], [[Insteon]], [[X10]], [[Z-Wave]] etc.) is added on the interface page first.  Then you add the actual lights here.  You can have a mix of systems ([[Z-Wave]] and [[X10]], for example).  For whatever interfaces you added, you will be able to add the lights here.  Blinds, drapes and motorized shutters are also treated as lights.</p>
 
<p>The Controlled VIA selection is where you choose what lighting control system is controlling this light.  You will also have to supply parameters specific to your type of lighting system, such as the house code for X10 devices, or the Channel for Lutron Radio RA.  You could also add generic relay-type devices here that use an interface module like the gc100.</p>
 
<p>The Controlled VIA selection is where you choose what lighting control system is controlling this light.  You will also have to supply parameters specific to your type of lighting system, such as the house code for X10 devices, or the Channel for Lutron Radio RA.  You could also add generic relay-type devices here that use an interface module like the gc100.</p>
  
 
<p>Port/Channel Number is your X10 house code and address.  For example, B3 would be house code "B" and light "3".  No spaces, quotes, or commas are needed.</p>
 
<p>Port/Channel Number is your X10 house code and address.  For example, B3 would be house code "B" and light "3".  No spaces, quotes, or commas are needed.</p>

Revision as of 21:15, 20 August 2007

Here you will add all the lights in your home. Note by lights we mean the actual light switches--not the lighting control system. The lighting control system (Lutron, Insteon, X10, Z-Wave etc.) is added on the interface page first. Then you add the actual lights here. You can have a mix of systems (Z-Wave and X10, for example). For whatever interfaces you added, you will be able to add the lights here. Blinds, drapes and motorized shutters are also treated as lights.</p>

The Controlled VIA selection is where you choose what lighting control system is controlling this light. You will also have to supply parameters specific to your type of lighting system, such as the house code for X10 devices, or the Channel for Lutron Radio RA. You could also add generic relay-type devices here that use an interface module like the gc100.

Port/Channel Number is your X10 house code and address. For example, B3 would be house code "B" and light "3". No spaces, quotes, or commas are needed.

Retrieved from "http://wiki.linuxmce.org/index.php?title=Lights&oldid=4711"