Difference between revisions of "RCS TXB16"
| (13 intermediate revisions by 8 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | [[Category: Hardware]] | |
| − | + | [[Category: Power Line Control]] | |
| + | [[Category: Climate]] | ||
| + | {{versioninfo}} | ||
| + | {{stub}} | ||
| + | |||
| + | [[Image:RCS_TXB16.jpg|right]] | ||
| + | |||
| + | ==Introduction== | ||
| + | LinuxMCE can control thermostats that are X10 compatible. | ||
==RCS TXB16== | ==RCS TXB16== | ||
Latest revision as of 16:01, 28 September 2010
| Version | Status | Date Updated | Updated By |
|---|---|---|---|
| 710 | Unknown | N/A | N/A |
| 810 | Unknown | N/A | N/A |
| 1004 | Unknown | N/A | N/A |
| 1204 | Unknown | N/A | N/A |
| 1404 | Unknown | N/A | N/A |
| Usage Information | |||
| This article is a stub and requires expansion |
Introduction
LinuxMCE can control thermostats that are X10 compatible.
RCS TXB16
Manufacturer: [RCS] This thermostat provides bi-directional X10 communication. Unfortunately, it uses up all 16 addresses of a house code. It consists of 2 parts, a wall display unit and a control unit. The wall display unit contains the temperature sensor, a LCD screen for temperature and setting outputs, buttons for raising or lowering the temperature, and should be installed where the old thermostat is attached.
The control unit is a bit ugly so it should be hidden in the boiler room or a closet. This unit contains the X10 control interface and has an X10 wall plug that needs to be plugged into an outlet. It also has another wall plug for power. Yes, that's 2 wall plugs - one for X10 communication, and one for power.
