Difference between revisions of "QOrbiter Setup"
From LinuxMCE
(→Configuration) |
(→Configuration) |
||
| (2 intermediate revisions by one other user not shown) | |||
| Line 12: | Line 12: | ||
*Quick Reload the router when asked. | *Quick Reload the router when asked. | ||
*Note: It is no longer needed to run qOrbiterGenerator.php. | *Note: It is no longer needed to run qOrbiterGenerator.php. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
==Running the device== | ==Running the device== | ||
| Line 37: | Line 25: | ||
In order to use qOrbiter from outside your internal LinuxMCE network, you need to: | In order to use qOrbiter from outside your internal LinuxMCE network, you need to: | ||
*Open ports 2757 & 3450 on your firewall via webadmin | *Open ports 2757 & 3450 on your firewall via webadmin | ||
| − | * | + | *Enter your public ip address to your core. Keep in mind there is no security, so you should be connecting via vpn |
| − | + | ||
[[Category:Programmer's Guide]][[Category:QML]][[category:QOrbiter]] | [[Category:Programmer's Guide]][[Category:QML]][[category:QOrbiter]] | ||
Latest revision as of 06:01, 30 June 2016
This page outlines what is needed to setup LinuxMCE to support a qOrbiter. These instructions are relevant for any qOrbiter running device. Some stuff only needs to be done ones (like the skin downloading), other stuff, like the creation of the Orbiter device, should be done for each qOrbiter device. Each qOrbiter-running hardware device should have a dedicated device ID.
Configuration
You will need to prepare for the addition of the device to your system before it can be used by following these steps.
- Navigate to the 'Orbiters' page in the LinuxMCE Admin website. Create a new QOrbiter device from the dropdown box at the bottom. Make sure you fill in all the information there like:
- User
- Room
- Size - This is a remnant of the old orbiter, choose the smallest one, so that any regen it does is fast.
- Make a note of the device number
- When done, choose update.
- When the core is ready, it will ask you to do a quick reload. MAKE SURE to set the default user and location.
- Quick Reload the router when asked.
- Note: It is no longer needed to run qOrbiterGenerator.php.
Running the device
- Assuming the previous steps were completed, you can now connect.
- The default ip it connects to is 192.168.80.1
- Enter the device number you previously made note of for the device number
- If your core address is not standard, it will hang. you can kill the device and edit the config.xml at the location listed below.
The configuration file is located on the SDCard under /LinuxMCE (for Android
Remote Access
In order to use qOrbiter from outside your internal LinuxMCE network, you need to:
- Open ports 2757 & 3450 on your firewall via webadmin
- Enter your public ip address to your core. Keep in mind there is no security, so you should be connecting via vpn
