Difference between revisions of "Motion"
From LinuxMCE
(→Introduction) |
|||
| Line 4: | Line 4: | ||
==Motion in Pluto== | ==Motion in Pluto== | ||
Pluto has a wrapper that connects to Motion. You add this wrapper as an "Interface" on the Interface page. It is called, "Motion Wrapper". You must have this interface prior to setting up your cameras. | Pluto has a wrapper that connects to Motion. You add this wrapper as an "Interface" on the Interface page. It is called, "Motion Wrapper". You must have this interface prior to setting up your cameras. | ||
| + | |||
| + | |||
| + | ==Compiling (contributing) to Motion Wrapper in Pluto== | ||
| + | On 0.41 version of Pluto I wanted to incorporate few changes into Motion wrapper. I decided to compile it and described procedure [[How_to_compile_Motion_Wrapper|here]]. | ||
Revision as of 16:40, 14 November 2006
| This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007. In general any information should apply to LinuxMCE. However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto. |
Motion is an open source surveillance camera recording software. Its homepage is found at [here] and is very well written and documented. Its main feature is that it detects motion (hence the name!) and can start recording based on motion criteria.
Motion in Pluto
Pluto has a wrapper that connects to Motion. You add this wrapper as an "Interface" on the Interface page. It is called, "Motion Wrapper". You must have this interface prior to setting up your cameras.
Compiling (contributing) to Motion Wrapper in Pluto
On 0.41 version of Pluto I wanted to incorporate few changes into Motion wrapper. I decided to compile it and described procedure here.
