Difference between revisions of "Access Point"
From LinuxMCE
(→Introduction) |
|||
| Line 1: | Line 1: | ||
== Introduction == | == Introduction == | ||
| − | This tutorial describes how to add Access Point functionality to your LMCE core. The core will act as a WiFi access point permitting wireless devices | + | This tutorial describes how to add Access Point functionality to your LMCE core. The core will act as a WiFi access point permitting wireless devices to connect to the core the internal network and the internet. |
== My hardware setup == | == My hardware setup == | ||
Revision as of 06:42, 28 September 2009
Contents
Introduction
This tutorial describes how to add Access Point functionality to your LMCE core. The core will act as a WiFi access point permitting wireless devices to connect to the core the internal network and the internet.
My hardware setup
- Dell Optiplex Gx620
- WiFi card with Atheros chipset (using madwifi drivers)
- Linux MCE 810 alpha2
Overview
the idea is to combine or bridge eth1 and ath0 to a new virtual interface called br0.
- -> eth0 connects to my ADSL modem (192.168.5.0)
- -> eth1 connects to my internal LAN switch (192.168.80.0)
- -> ath0 connects the wireless part of my internal network (192.168.80.0)
Needed packages
- hostapd
- bridge
Config files
/etc/network/interfaces
/etc/default/dhcp.conf
/etc/default/dhcpd3/dhcpd.conf
Enable WPA encryption
- edit the /etc/hostapd
