Difference between revisions of "EIB/KNX Devices"
From LinuxMCE
(New page: Category: Serial Category: EIB To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 75060...) |
(Added note about EIB/KNX over Powernet.) |
||
| Line 4: | Line 4: | ||
To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 750600xx). | To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 750600xx). | ||
If you try to use the new driver, you can use any connector because it works with eibd ([[EIB/KNX with eibd]]). | If you try to use the new driver, you can use any connector because it works with eibd ([[EIB/KNX with eibd]]). | ||
| + | |||
| + | == EIB/KNX over Powernet == | ||
| + | There is no direct serial bus connector for EIB over Powernet. One way to circumvent this problem, is to use a "Systemkoppler 6987/10" from Busch-Jäger. | ||
| + | |||
| + | The Systemkoppler is used to connect EIB over Powernet to an EIB over Twisted Pair installation. All telegrams pass easily between those installs. | ||
Revision as of 16:13, 20 November 2009
To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 750600xx).
If you try to use the new driver, you can use any connector because it works with eibd (EIB/KNX with eibd).
EIB/KNX over Powernet
There is no direct serial bus connector for EIB over Powernet. One way to circumvent this problem, is to use a "Systemkoppler 6987/10" from Busch-Jäger.
The Systemkoppler is used to connect EIB over Powernet to an EIB over Twisted Pair installation. All telegrams pass easily between those installs.
