InteractiveTechnologies CueServer-Pro-CS-800: Difference between revisions
Gonesurfing (talk | contribs) New page: Category: Automation Category: hardware This is a template for a DMX lighting controller by Interactive technologies - model Cueserver pro800 http://www.interactive-online.com/p... |
Gonesurfing (talk | contribs) No edit summary |
||
| Line 9: | Line 9: | ||
if cmd.id_==192 #192 is on | if cmd.id_==192 #192 is on | ||
conn_.Send("[c"+id+"atfl]\r") #set id to full | conn_.Send("[c"+id+"atfl]\r") #set id to full | ||
end | end | ||
if cmd.id_==193 #193 is off | if cmd.id_==193 #193 is off | ||
conn_.Send("[c"+id+"rel]\r") #relase id to zero | conn_.Send("[c"+id+"rel]\r") #relase id to zero | ||
end | end | ||
if cmd.id_==184 #184 dimmer | if cmd.id_==184 #184 dimmer | ||
conn_.Send("[c"+id+"at50]\r") #set id to 50% it should step the light up or down this is not working at present | conn_.Send("[c"+id+"at50]\r") #set id to 50% it should step the light up or down this is not working at present | ||
end | end | ||
THINGS TO DO | THINGS TO DO | ||
-get #184 the dimmer command to work correctly | -get #184 the dimmer command to work correctly | ||
-add log/messages to keep lmce up to date | -add log/messages to keep lmce up to date | ||
-intergrate the 8 contact closures on the cueserver this could work as alarm interface | -intergrate the 8 contact closures on the cueserver this could work as alarm interface | ||
-get it to work over the ethernet c++ | |||
-get it to work over the ethernet write a driver in c++ | |||
Revision as of 08:16, 5 September 2010
This is a template for a DMX lighting controller by Interactive technologies - model Cueserver pro800 http://www.interactive-online.com/products/cueserver/overview Its very basic at the moment however it is working using the serial port I have followed the guide in the wiki "Implementing Clipsal Interface using Generic Serial Device"also adding in device data #76 COM Port ParityBit/Stop(string) #78 COM Port BaudRate(string)
in the RUBY CODE under "Ruby Internal Commands"-"#384 Process Receive Command For Child "add
id=device_.childdevices_[cmd.devidto_].devdata_[12]#get child device number
if cmd.id_==192 #192 is on
conn_.Send("[c"+id+"atfl]\r") #set id to full
end
if cmd.id_==193 #193 is off
conn_.Send("[c"+id+"rel]\r") #relase id to zero
end
if cmd.id_==184 #184 dimmer
conn_.Send("[c"+id+"at50]\r") #set id to 50% it should step the light up or down this is not working at present
end
THINGS TO DO
-get #184 the dimmer command to work correctly
-add log/messages to keep lmce up to date
-intergrate the 8 contact closures on the cueserver this could work as alarm interface
-get it to work over the ethernet write a driver in c++