Difference between revisions of "Firewall Rules"
(→Limit IP) |
|||
| Line 2: | Line 2: | ||
[[Category:Admin Website]] | [[Category:Admin Website]] | ||
[[Category:Networking]] | [[Category:Networking]] | ||
| − | |||
| − | |||
[[Image:Firewall.jpg|thumb|200px|Firewall Rules Admin Page]] | [[Image:Firewall.jpg|thumb|200px|Firewall Rules Admin Page]] | ||
Revision as of 23:34, 19 October 2012
| Version | Status | Date Updated | Updated By |
|---|---|---|---|
| 710 | Unknown | N/A | N/A |
| 810 | relevant | 21 Aug 2011 | Foxi352 |
| 1004 | relevant | 21 Aug 2011 | Foxi352 |
| 1204 | Unknown | N/A | N/A |
| 1404 | Unknown | N/A | N/A |
| Usage Information | |||
This page allows you to customize your firewall rules, even disabling the firewall. When first opened you will notice that there are several predefined rules already in place.
Contents
Options
Protocol
Here is where you can choose the protocol involved with this rule, or define any protocol by choosing 'IP':
IP version
Here you can choose if you want the rule to be active for IPv4, IPv6 or both.
Source Ports
Choose the Ports to be used in the rule. If you chose 'IP' in the Protocol section then you can define your IP protocol (NOT PORT !!!) number here.
Destination Port
Port to forward requests to.
This option is only available if Port Forwarding is selected in the Rule Type
Destination IP
IP Address of the computer being forwarded to.
This option is only available if Port Forwarding is selected in the Rule Type
Rule Type
There are two types of rules available:
- Core Input
- Port Forward
Limit IP
You can limit rules to specific IP addresses.
It looks like you can add the mask to specify ranges: 134.78.0.0/16
