Difference between revisions of "InteractiveTechnologies CueServer-Pro-CS-800"

Latest revision as of 15:51, 11 July 2016

This is a template for a DMX lighting controller by Interactive technologies - model Cueserver pro800 Its very basic at the moment however it is working using the serial port I have followed the guide in the wiki "Implementing Clipsal Interface using Generic Serial Device"also adding in device data #76 COM Port ParityBit/Stop(string) #78 COM Port BaudRate(string)

in the RUBY CODE under "Ruby Internal Commands"-"#384 Process Receive Command For Child "add

id=device_.childdevices_[cmd.devidto_].devdata_[12]#get child device number
if cmd.id_==192 #192 is on
  conn_.Send("[c"+id+"atfl]\r") #set id to full
end
if cmd.id_==193 #193 is off
  conn_.Send("[c"+id+"rel]\r") #relase id to zero
end
if cmd.id_==184 #184 dimmer
  conn_.Send("[c"+id+"at50]\r") #set id to 50% it should step the light up or down this is not working at present
end

Things To Do

• get #184 the dimmer command to work correctly
• add log/messages to keep lmce up to date
• intergrate the 8 contact closures on the cueserver this could work as alarm interface
• get it to work over the ethernet write a driver in c++