Difference between revisions of "DCE Binary Communication Protocol"

Revision as of 13:55, 16 May 2007

Introduction

A device can create a command connection and one or more event connections to the router.

The command connection is used as an incoming connection and device will use it to receive message from the router (commands).

An event connection is used by the device as an outgoing connection to notify the router about events or the deliver commands to other devices.

The DCERouter process is listening on 3450 port.

How to create an event connection

Here is how the handshake is made for an event connection:

>> Device sends:

HELLO <my_device_id> '\n'

<< To router can response with :

NOT IN THIS INSTALLATION IP=<device_ip_address> '\n'

or

OK 43 IP=<device_ip_address> '\n'

>> Device sends:

EVENT 43 '\n'

<< To router will response with :

OK 43 IP=<device_ip_address> '\n'

>> To send a message, the device will send :

MESSAGE <size_of_binary_message> '\n'

and then

<serialized_binary_message>

How to create a command connection

Here is how the handshake is made for an event connection:

>> Device sends:

HELLO <my_device_id> '\n'

<< To router can response with :

NOT IN THIS INSTALLATION IP=<device_ip_address> '\n'

or

OK 43 IP=<device_ip_address> '\n'

>> Device sends:

COMMAND 43 '\n'

<< To router will response with :

OK 43 IP=<device_ip_address> '\n'

>> The device will wait for messages from dcerouter; the router will send :

MESSAGE <size_of_binary_message> '\n'

and then

<serialized_binary_message>

How to serialize a message

How to serialize data

How to serialize data-grids