Sensors

This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007. In general any information should apply to LinuxMCE. However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto.

==Sending events from command line==

There is a utility in pluto (/usr/pluto/bin) that allows sending proper DCE message from command line. If you want for instance to trip motion sensors on/off you can achieve this in simple way (ID means ID of particular device that you send event for) :

Event "tripped on"

ID -1000 2 9 25 1

Event "tripped off"

ID -1000 2 9 25 0

Event "temperature changed"

ID  -1000 2 25 30 temperature_value

Event "output on"

ID  -1000 2 28

Event "output off"

ID  -1000 2 29

For instance - tripping security sensor with ID of 195 to ON :

/usr/pluto/bin/MessageSend dcerouter 195 -1000 2 9 25 1