DVD Install And Custom Partitions
Usually, a DVD install will create a standard partitioning schema, where the harddisk is split into 3 areas
sda1 = / (everything except the last 12GB) sda5 = swap (2GB) sda6 = /mnt/recovery (10GB)
This setup caused a problem because the hard drive space available was 1.8TB. And the BIOS and/or grub had problems installing relevant files. The following steps are for people who want to install LinuxMCE with a custom partition scheme.
Partition the disk
Before the real LinuxMCE installation, the hard disk needs to be partitioned and setup the way we want to. To do that, boot your computer (not an installation) with any Linux liveCD. After boot-up, press <ALT><F2> to get a command shell prompt.
Execute
sudo fdisk /dev/xxxx
where /dev/xxxx is the device you want to partition.
Now use fdisk to create the partitions. The first partition should be big enough to hold LinuxMCE. I chose 80GB, to be on the safe side. After that, create an extended partition for the rest of the available disk space. Within the extended partition, first create a logical partition for the Linux swap space of say 2GB, then a logical partition for the rescue partition of 10GB. The rest of the space, you can partition to your liking. I ended up with this
sda1 = 80GB / sda5 = 2GB Linux Swap sda6 = 10GB /mnt/recovery sda7 = 1.7xTB rest
Instead of using fdisk you can use any other tool you might have. Just make sure to have partitions 1,5 and 6. After creating the partitions, the partitions need to be formatted.
sda1 = sudo mkfs.ext3 /dev/sda1 sda5 = sudo mkswap /dev/sda5 sda6 = sudo mkfs.ext2 /dev/sda6 sda7 = sudo mkfs.ext3 /dev/sda7
The first three are important. The partitions you are creating after the recovery partition, can be anything you like. Now the partitioning is the way we like it.
Marking The Hard Drive As A LinuxMCE Installation
LinuxMCE would repartition the hard disk now, if you would just start the DVD installer. We need fool the LinuxMCE Installer into believing we already have a LinuxMCE installation. To do so we have to create a single file. If you are using the LMCE DVD, it has created the /media/target directory to use below, but if you are using another live CD/DVD, then you need to mount /dev/sda1 somewhere on your system to create the following files inside the sda1 partition.
sudo mount /dev/sda1 /media/target sudo mkdir /media/target/etc sudo touch /media/target/etc/pluto.conf
Done. A restart of your system with the LinuxMCE DVD in the drive, and LinuxMCE installer will prompt you, if you want to keep your installation. I chose option 2, meaning just the home dir. LinuxMCE installer will now go ahead and install the new system, while preserving your partitions. Upon restarting, the AV Wizard and House Setup, all other partitions will be detected and you will be asked how do you want to use them. Choose LinuxMCE directory structure, and everything is fine.
