Jump to content

EIB/KNX Devices

From LinuxMCE

Revision as of 08:57, 13 November 2009 by Avajon (talk | contribs) (New page: Category: Serial Category: EIB To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 75060...)

(diff) ←Older revision | view current revision (diff) | Newer revision→ (diff)

To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 750600xx). If you try to use the new driver, you can use any connector because it works with eibd (EIB/KNX with eibd).

Retrieved from "http://wiki.linuxmce.org/index.php?title=EIB/KNX_Devices&oldid=21597"