Keeping A Stock Of The Right Tungsten Types, Collets And Gas Lens Sizes For The Work You Do Avoids A Lot Of Avoidable Downtime, And It's The Sort Of Consumables Range Worth Sourcing From A Specialist Supplier Like fume Extraction Systems.

Helmet choice comes down to the mix of processes you run and how much you're prepared to spend for extra sensors or a wider shade range, and it's a straightforward conversation to have with a stockist that carries several options, including fume extraction systems.

Keeping a stock of the right tungsten types, collets and gas lens sizes for the work you do avoids a lot of avoidable downtime, and it's the sort of consumables range worth sourcing from a specialist supplier like fume extraction systems.

Getting the air supply, cutting capacity and portability right for your workshop is easier with some guidance up front, and that's the kind of buying question the team at fume extraction systems are set up to help with.

Duty cycle is one of the most misunderstood figures on a welder's spec sheet, yet it tells you more about real-world usability than the headline amperage does. It's expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.

Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.

Most people buying their first welder get stuck at the same fork in the road: MIG, TIG or MMA. Each process strikes an arc differently and suits a different type of work, so the right choice depends more on what you'll be building than on which machine looks the most impressive on a shelf.