Difference between revisions of "ACT Homepro ZDW232"
From LinuxMCE
| Line 11: | Line 11: | ||
*ZDW232 can be programmed as a routing slave to establish firm signal routes and can be "associated" with other Z-wave devices in order to control them. | *ZDW232 can be programmed as a routing slave to establish firm signal routes and can be "associated" with other Z-wave devices in order to control them. | ||
*ZDW232 can be configured to Control Shades or Window Coverings via Z-Wave network. | *ZDW232 can be configured to Control Shades or Window Coverings via Z-Wave network. | ||
| + | |||
| + | = Advanced Features = | ||
| + | * Night Light | ||
| + | * Invers Switch | ||
| + | * Adjusting Dim Rate | ||
| + | |||
= Caveats = | = Caveats = | ||
Revision as of 23:41, 27 June 2010
| Version | Status | Date Updated | Updated By |
|---|---|---|---|
| 710 | According to category, Works without caveats | 27th Jun 2010 | Valent |
| 810 | According to category, Works without caveats | 11th May 2010 | Valent |
| 1004 | Unknown | N/A | N/A |
| 1204 | Unknown | N/A | N/A |
| 1404 | Unknown | N/A | N/A |
| Usage Information | |||
Contents
Features
- The ZDW232 is a single dimming receiver which controls the connected load ON/OFF and DIM/BRIGHT and also serves as a transmitter using multiple switch taps (controls one group of 5 Z-Wave modules).
- ZDW232 replaces an existing wall switch.
- ZDW232 can be programmed as a routing slave to establish firm signal routes and can be "associated" with other Z-wave devices in order to control them.
- ZDW232 can be configured to Control Shades or Window Coverings via Z-Wave network.
Advanced Features
- Night Light
- Invers Switch
- Adjusting Dim Rate
Caveats
Do not connect regulat CFL bulbs to this switch because if they aren't special dimmable CFL bulbs.
About
This is the 2-wire version, there is also a 3-wire version (ZDW230) available.
