Difference between revisions of "AVWizard script based user callable events"

From LinuxMCE
Jump to: navigation, search
 
(11 intermediate revisions by one other user not shown)
Line 1: Line 1:
<table width="100%"> <tr><td bgcolor="#FFCFCF">This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007.  In general any information should apply to LinuxMCE.  However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto.</td></tr> </table>At events the possible actions that user may do:
+
At events the possible actions that user may do:
- '''$default''': do the same as default asks;
+
  - '''$skip'''  
- '''$skip''': does nothing, skipping the default event. To call it after, you must expressly call $default code;
+
Does nothing, skipping the default event.  
- '''$previous''': close the current screen and go to the previous;
+
 
- '''$next ['FileName']''': save the current items on the selected page.
+
  - '''$previous'''
FileName is used to skip some steps in the wizard. If the wizard is in  
+
Close the current screen (page) and go to the previous one
“One-Page mode” will finish the settings right here;
+
 
- '''$call 'scriptname' ''': calls one system command;
+
  - '''$next ['FileName']'''
- '''$next_item''': focus on next focus-able item;
+
Save the current items on the selected page. FileName is used to skip some steps in the wizard. If the wizard is in “One-Page mode” will finish the settings right here.
- '''$previous_item''': focus on the previous focus-able item;
+
 
- '''$refresh 'FileName' ''' : reload the description form in file FileName;
+
  - '''$call 'scriptname' '''
- '''$call_event [Object.]Event''': call the event of one specified control;
+
Calls one system command;
- '''$set_property [Object].Property [= Value]''': set a value to one item.  
+
 
If there is no value written, the control will get the defaults. After that,
+
  - '''$focus CaptionControl'''
will be called the OnPaint event, except if the control is in ''skipping state''
+
Focus the control that has the caption selected one. For ListBox the caption is ListBox1, etc.
(given by command '''$skip''')
+
[[Category: Programmer's Guide]]

Latest revision as of 01:18, 4 October 2007

At events the possible actions that user may do:

 - $skip 

Does nothing, skipping the default event.

 - $previous

Close the current screen (page) and go to the previous one

 - $next ['FileName']

Save the current items on the selected page. FileName is used to skip some steps in the wizard. If the wizard is in “One-Page mode” will finish the settings right here.

 - $call 'scriptname' 

Calls one system command;

 - $focus CaptionControl

Focus the control that has the caption selected one. For ListBox the caption is ListBox1, etc.