Difference between revisions of "DCE Binary Communication Protocol"

From LinuxMCE
Jump to: navigation, search
(How to serialize data)
(How to serialize data)
Line 90: Line 90:
  
 
- 4 bytes, long, value must be 1234 //magic number
 
- 4 bytes, long, value must be 1234 //magic number
 +
 
- 4 bytes, unsigned long
 
- 4 bytes, unsigned long
 +
 
- 1 byte, unsigned char
 
- 1 byte, unsigned char
 +
 
- 4 bytes, long, value must be 5678 //magic number
 
- 4 bytes, long, value must be 5678 //magic number
  

Revision as of 14:04, 16 May 2007

Introduction

A device can create a command connection and one or more event connections to the router.

The command connection is used as an incoming connection and device will use it to receive message from the router (commands).

An event connection is used by the device as an outgoing connection to notify the router about events or the deliver commands to other devices.

The DCERouter process is listening on 3450 port.

How to create an event connection

Here is how the handshake is made for an event connection:

>> Device sends:

HELLO <my_device_id> '\n'


<< To router can response with :

NOT IN THIS INSTALLATION IP=<device_ip_address> '\n'

or

OK 43 IP=<device_ip_address> '\n'


>> Device sends:

EVENT 43 '\n'


<< To router will response with :

OK 43 IP=<device_ip_address> '\n'


>> To send a message, the device will send :

MESSAGE <size_of_binary_message> '\n'

and then

<serialized_binary_message>

How to create a command connection

Here is how the handshake is made for an event connection:

>> Device sends:

HELLO <my_device_id> '\n'


<< To router can response with :

NOT IN THIS INSTALLATION IP=<device_ip_address> '\n'

or

OK 43 IP=<device_ip_address> '\n'


>> Device sends:

COMMAND 43 '\n'


<< To router will response with :

OK 43 IP=<device_ip_address> '\n'


>> The device will wait for messages from dcerouter; the router will send :

MESSAGE <size_of_binary_message> '\n'

and then

<serialized_binary_message>

How to serialize data

DCE uses SerializeClass to serialize/deserialize data.

The sources can be found here : src/SerializeClass/Serialize.h/cpp.

The deserialize the data, the deserializing module must know the way the data was serialized like this:

- 4 bytes, long, value must be 1234 //magic number

- 4 bytes, unsigned long

- 1 byte, unsigned char

- 4 bytes, long, value must be 5678 //magic number

How to serialize a message

The class used by DCE is Message class from src/DCE/Message.h/cpp unit.

How to serialize data-grids