Difference between revisions of "Doorbell"

From LinuxMCE
Jump to: navigation, search
(small note on how to setup a switch as a doorbell)
(Added note about sensor tripped)
Line 9: Line 9:
 
* Go to Active Sensors and mark the newly added sensor as Doorbell.  
 
* Go to Active Sensors and mark the newly added sensor as Doorbell.  
 
* Done.
 
* Done.
 +
 +
== Do something when the door bell rings ==
 +
At the moment the doorbell event does NOT work. However, a sensor tripped event does work. Set tripped = 1, and leave the time constraint empty.
  
 
==LinuxMCE DoorBell==
 
==LinuxMCE DoorBell==

Revision as of 13:35, 28 August 2011


The following information CAN NOT be verified at the moment posde

Using a switch

  • Setup a switch in the security sensors. Use type Door.
  • Go to Active Sensors and mark the newly added sensor as Doorbell.
  • Done.

Do something when the door bell rings

At the moment the doorbell event does NOT work. However, a sensor tripped event does work. Set tripped = 1, and leave the time constraint empty.

LinuxMCE DoorBell

Part of LinuxMCE's capabilities include the ability to setup a doorbell that connects to the system and can provide you with many extended features such as:

  • Remote Unlocking of doors
  • Viewing callers to your home

Adding A Doorbell

This functionality can be achieved by:
  • Obtaining a compatible door-phone and registering it with LinuxMCE as extension 994. Compatible means:
    • A IP-phone door-phone capable of registering with LinuxMCE.
    • An analog door-phone system that can be connected to an analog telephone adapter that can register with LinuxMCE.
After this is done, whenever the extension is triggered, it will ring mobile orbiters and any cell phone orbiters listed in the webadmin.

Other Features

  • Picture: Adding a camera in the area of the doorbell should initiate LinuxMCE adding a picture of the door
  • Depending on the device, other features such as remote unlocking can be added.