Difference between revisions of "E-Fon (Switzerland)"

From LinuxMCE
Jump to: navigation, search
(Imported document)
 
 
(4 intermediate revisions by 2 users not shown)
Line 1: Line 1:
<table width="100%"> <tr><td bgcolor="#FFCFCF">This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007.  In general any information should apply to LinuxMCE.  However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto.</td></tr> </table><h2>Setup for <b>E-FON</b></h2>
+
[[Category: VoIP]]
 +
[[Category: Telecom]]
 +
[[Category: Phone Lines]]
 +
 
 +
 
 +
<h2>Setup for <b>E-FON</b></h2>
 +
http://www.e-fon.ch/
 +
==Automatic Setup==
 +
The setup is automatic from the House Setup Wizard using the following script
 +
    /usr/pluto/bin/create_amp_efon.pl
 +
==Manual Setup==
 
<p>Go to 'Trunks' section</p>
 
<p>Go to 'Trunks' section</p>
 
<p>Add a IAX2 trunk</p>
 
<p>Add a IAX2 trunk</p>
Line 36: Line 46:
 
<p>Select the extension to ring, or select default incoming extension</p>
 
<p>Select the extension to ring, or select default incoming extension</p>
 
<p>Apply your changes by clicking on red line.</p>
 
<p>Apply your changes by clicking on red line.</p>
 

Latest revision as of 23:28, 19 October 2012


Setup for E-FON

http://www.e-fon.ch/

Automatic Setup

The setup is automatic from the House Setup Wizard using the following script

   /usr/pluto/bin/create_amp_efon.pl

Manual Setup

Go to 'Trunks' section

Add a IAX2 trunk

On 'Outgoing Dial Rules' add

9|.
this will be the prefix to place call to E-FON network

On 'Outgoing Settings' set trunk name to

efon
and peer details to
callow=alaw
auth=md5
callerid="YOUR_NAME" YOUR_EFON_NUMBER
canreinvite=no
disallow=all
host=YOUR_EFON_PROXY
nat=yes
qualify=no
secret=YOUR_EFON_PASSWORD
type=peer
username=YOUR_EFON_NUMBER

On 'Incoming Settings' set usercontext to

YOUR_EFON_NUMBER
and user details to
auth=md5
context=from-pstn
secret=YOUR_EFON_PASSWORD
type=user
username=YOUR_EFON_NUMBER

On 'Registration' set registration string to

YOUR_EFON_NUMBER:YOUR_EFON_PASSWORD@YOUR_EFON_PROXY

Go to Outbound Routing section

Set route name to

efon

Set dial patterns to

9|.

Set trunk sequence to

IAX2/efon

Go to DID Routes section

Set number to

YOUR EFON NUMBER

Select the extension to ring, or select default incoming extension

Apply your changes by clicking on red line.