Difference between revisions of "EIB/KNX Devices"
From LinuxMCE
(Added note about EIB/KNX over Powernet.) |
(→EIB/KNX over Powernet) |
||
| Line 9: | Line 9: | ||
The Systemkoppler is used to connect EIB over Powernet to an EIB over Twisted Pair installation. All telegrams pass easily between those installs. | The Systemkoppler is used to connect EIB over Powernet to an EIB over Twisted Pair installation. All telegrams pass easily between those installs. | ||
| + | |||
| + | The 6987/10 can be used as a PSU for the TP bus for up to 5 TP devices. | ||
Revision as of 17:20, 20 November 2009
To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 750600xx).
If you try to use the new driver, you can use any connector because it works with eibd (EIB/KNX with eibd).
EIB/KNX over Powernet
There is no direct serial bus connector for EIB over Powernet. One way to circumvent this problem, is to use a "Systemkoppler 6987/10" from Busch-Jäger.
The Systemkoppler is used to connect EIB over Powernet to an EIB over Twisted Pair installation. All telegrams pass easily between those installs.
The 6987/10 can be used as a PSU for the TP bus for up to 5 TP devices.
