Difference between revisions of "EIB/KNX Devices"
From LinuxMCE
(→EIB/KNX over Powernet) |
Wierdbeard65 (Talk | contribs) m |
||
| Line 1: | Line 1: | ||
[[Category: Serial]] | [[Category: Serial]] | ||
[[Category: EIB]] | [[Category: EIB]] | ||
| − | + | {{versioninfo}} | |
To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 750600xx). | To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 750600xx). | ||
If you try to use the new driver, you can use any connector because it works with eibd ([[EIB/KNX with eibd]]). | If you try to use the new driver, you can use any connector because it works with eibd ([[EIB/KNX with eibd]]). | ||
Revision as of 10:36, 2 May 2010
| Version | Status | Date Updated | Updated By |
|---|---|---|---|
| 710 | Unknown | N/A | N/A |
| 810 | Unknown | N/A | N/A |
| 1004 | Unknown | N/A | N/A |
| 1204 | Unknown | N/A | N/A |
| 1404 | Unknown | N/A | N/A |
| Usage Information | |||
To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 750600xx). If you try to use the new driver, you can use any connector because it works with eibd (EIB/KNX with eibd).
EIB/KNX over Powernet
There is no direct serial bus connector for EIB over Powernet. One way to circumvent this problem, is to use a "Systemkoppler 6987/10" from Busch-Jäger.
The Systemkoppler is used to connect EIB over Powernet to an EIB over Twisted Pair installation. All telegrams pass easily between those installs.
The 6987/10 can be used as a PSU for the TP bus for up to 5 TP devices.
