EIB/KNX Devices

From LinuxMCE
Revision as of 09:57, 13 November 2009 by Avajon (Talk | contribs) (New page: Category: Serial Category: EIB To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 75060...)

(diff) ←Older revision | view current revision (diff) | Newer revision→ (diff)
Jump to: navigation, search


To connect LinuxMCE (with the "old" driver) with your EIB/KNX environment you MUST use a serial bus connector. I use a Berker FT1.2 (order nr. 750600xx). If you try to use the new driver, you can use any connector because it works with eibd (EIB/KNX with eibd).