Difference between revisions of "Medion MD1 NBC"
From LinuxMCE
| Line 2: | Line 2: | ||
[[Category: Input]] | [[Category: Input]] | ||
[[Category: Supported]] | [[Category: Supported]] | ||
| + | ===Medion MD1 NBC=== | ||
| + | [[Image:Medion-MD1-NBC.jpg|Medion MD1 NBC RF Remote Control]] | ||
| − | |||
| − | |||
| − | |||
Medion MD1 NBC (Made in China by X10) is a RF Remote Controler. | Medion MD1 NBC (Made in China by X10) is a RF Remote Controler. | ||
| Line 21: | Line 20: | ||
Technical Specification: | Technical Specification: | ||
| + | |||
It has CE mark so it is approved for use in the EU. | It has CE mark so it is approved for use in the EU. | ||
*RF Frequency: 433 MHz | *RF Frequency: 433 MHz | ||
| Line 37: | Line 37: | ||
</code> | </code> | ||
as root or deleting the module. | as root or deleting the module. | ||
| + | |||
| + | My [[Medion-MD1-NBC-lirc.conf|lircd.conf]]. | ||
Revision as of 23:41, 7 January 2008
Medion MD1 NBC
Medion MD1 NBC (Made in China by X10) is a RF Remote Controler.
It has all (almost) what you need to control your LinuxMCE. It uses 2 x 1.5V AAA batteries.
- P/N: 20018268
- FCC ID: B4S20018268
I`ve got it along with KNC ONE TV-Station DVR analog tv tuner card.
X10 Receiver
The X10 RF receiver need to be connected directly into the mainboard USB pin.
- P/N: 20018267
Technical Specification:
It has CE mark so it is approved for use in the EU.
- RF Frequency: 433 MHz
- Operating range: 30m or 60feet (open field)
- Can support up to 16 remotes
- Works through walls using RF technology even when not aimed at the receiver
Setup
The device works with LMCE using LIRC. I`ve configured my device using Add_support_for_new_remote_controls guide.
Note:LinuxMCE will automatically load ati_remote kernel module which doesn`t seem to work. You need to prevent doing this by either doing
echo "blacklist ati_remote" >>/etc/modprobe.d/blacklist
as root or deleting the module.
My lircd.conf.
