Difference between revisions of "Merten 5024xx Connect Sensor Cover"
From LinuxMCE
| Line 1: | Line 1: | ||
| + | [[Category: Hardware]] | ||
[[Category: Automation]] | [[Category: Automation]] | ||
[[Category: Lighting]] | [[Category: Lighting]] | ||
Latest revision as of 16:52, 28 September 2010
| Version | Status | Date Updated | Updated By |
|---|---|---|---|
| 710 | Unknown | N/A | N/A |
| 810 | Unknown | N/A | N/A |
| 1004 | Unknown | N/A | N/A |
| 1204 | Unknown | N/A | N/A |
| 1404 | Unknown | N/A | N/A |
| Usage Information | |||
Contents
Status
Works.
About
The Merten 5024xx is a push button that fits onto the Merten relay (and electronic switches?) of the Connect series.
Features
- Really consists of 2 buttons: top and bottom half.
Device setup
Device type: Receiver
Inclusion/Exclusion/Node Info Frame
- Triple click on connected switch within approx. 1.5 seconds.
Parameter values
| Function | Value |
|---|---|
|
Switching additional CONNECT radio receivers |
0 |
Factory reset
- Press the connected button 3 times within 1.5 seconds. The LED will flash.
- Press and hold the button for about 5 seconds until the LED turns off.
