Difference between revisions of "Message Translation"
From LinuxMCE
| Line 1: | Line 1: | ||
<table width="100%"> <tr><td bgcolor="#FFCFCF">This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007. In general any information should apply to LinuxMCE. However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto.</td></tr> </table>== Short description == | <table width="100%"> <tr><td bgcolor="#FFCFCF">This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007. In general any information should apply to LinuxMCE. However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto.</td></tr> </table>== Short description == | ||
| + | |||
| + | Used to translate between ''toggle'' and ''discrete'' commands (usually for infrared equipment). | ||
| + | When a device only accepts toggle commands and it receives an "ON" or "OFF", it will be translated into "TOGGLE_POWER" depending on device status. | ||
| + | Same is true then device accepts dicrete commands, but the remote has only toggle button, in this case we will send "ON" or "OFF", again it depends on device state. | ||
== Available translations == | == Available translations == | ||
Revision as of 13:57, 23 May 2006
| This page was written by Pluto and imported with their permission when LinuxMCE branched off in February, 2007. In general any information should apply to LinuxMCE. However, this page should be edited to reflect changes to LinuxMCE and remove old references to Pluto. |
Used to translate between toggle and discrete commands (usually for infrared equipment). When a device only accepts toggle commands and it receives an "ON" or "OFF", it will be translated into "TOGGLE_POWER" depending on device status. Same is true then device accepts dicrete commands, but the remote has only toggle button, in this case we will send "ON" or "OFF", again it depends on device state.
