Difference between revisions of "Panasonic PT-56WX33G"

From LinuxMCE
Jump to: navigation, search
Line 10: Line 10:
  
 
Note- I'm selecting VGA as the option in the AV Wizard, but using the DVI port on the video card and tv input.
 
Note- I'm selecting VGA as the option in the AV Wizard, but using the DVI port on the video card and tv input.
 +
 +
 +
(11/29/09) Recent changes to the video drivers (note- this is pre Beta 2) have made the above suggestions poor.  When the above selections are made, only about 1/4 of the screen is shown on the TV, but it takes up the whole display.  To get it going, I've had to select 640x480.

Revision as of 03:58, 30 November 2009


Panasonic CinemaVision 56" Rear Projection TV

There is a DVI port on the back of the TV that the manual says specifically is not for connection to a computer....


(8/15/2009) That said, LMCE 8.10 alpha 29 puts out a great signal using the VGA selection at 1280x1024 resolution at 60Hz BUT (and this is a major but) if you go to the KDE desktop all of the sizes are cut off- I think there are work arounds for this, but it's not ideal. VGA 1024x768 @ 75 hz is the best I've seen but VGA 800x600 at 60Hz OK too.

Note- I'm selecting VGA as the option in the AV Wizard, but using the DVI port on the video card and tv input.


(11/29/09) Recent changes to the video drivers (note- this is pre Beta 2) have made the above suggestions poor. When the above selections are made, only about 1/4 of the screen is shown on the TV, but it takes up the whole display. To get it going, I've had to select 640x480.