Difference between revisions of "Status"

From LinuxMCE
Jump to: navigation, search
(Added Screenshots)
m
 
Line 1: Line 1:
 +
{{Versioninfo}}
 
[[Category: Admin Website]]
 
[[Category: Admin Website]]
 
[[Category: Security]]
 
[[Category: Security]]

Latest revision as of 08:19, 3 May 2010

Version Status Date Updated Updated By
710 Unknown N/A N/A
810 Unknown N/A N/A
1004 Unknown N/A N/A
1204 Unknown N/A N/A
1404 Unknown N/A N/A
Usage Information
Security Status Admin Page

This allows you to manually set the individual sensors in your home. You can change the mode for that sensor independently. For example, instead of arming the whole house, you can arm just a few sensors. You can also change the 'Bypass' setting for each sensor. 'Normal' means the sensor is not bypassed. 'Wait' means the sensor is waiting however many seconds you specified in the 'Wait before alarm' setting before becoming active. It will return to 'Normal' after that many seconds. 'Bypass' means you have bypassed this sensor this one time. As soon as someone enters the PIN code on Orbiter the sensor will not be bypassed anymore. 'Perm bypass' means the sensor is bypassed and will stay bypassed until you change it again here on this page.

If you want to permanently disable a certain sensor, you could go to the Wizard/Security/Respond to Sensors page and change that sensor to "Do nothing". That allows you to disable the sensor for only certain modes (like armed or sleeping). Or you can set it to "Perm bypass" on this page. That means the sensor is permanently bypassed for all modes no matter what you put on the Respond to Sensors page.