Difference between revisions of "Tesco Internet Phone"

From LinuxMCE
Jump to: navigation, search
Line 27: Line 27:
 
     00ZXXXXXXXXXX
 
     00ZXXXXXXXXXX
 
     161+XXXXXXX
 
     161+XXXXXXX
 +
 +
Replace the 161 with your area code, if you live in an area with a 4 figure area code and a six figure number then lose an X and replace the 161 with your area code without the zero at the front
  
 
Hit the 'Submit' button
 
Hit the 'Submit' button

Revision as of 06:17, 22 March 2009

www.tescointernetphone.com

Manual Setup

The article describes setting up the Tesco Internet Phone from the 'Phone Lines' page of the Web Admin interface.

1. From the pull down menu select 'teliax'

2. Type in the Information requested:

  Username:       (this is your Tesco Internet Phone Number)
  Password:       (your Password)
  Phone Number:   (Your number, same as your username)
  Host:           gateway.tescointernetphone.com

Then hit 'submit'

3. Hit the 'Deactivate Automatic Configuration' button

4. The prompt says 'Are you sure you want to activate manual phone lines configuration?', hit the yes button

5. The prompt says 'Manual configuration activated. To configure AMP, click click here', hit the 'click here' link

6. Select 'Outbound Routes', on the right hand side click on '0 teliax-out-route'

7. Copy and Paste the following into the 'dial patterns' box:

   999
   0044|0+.
   00ZXXXXXXXXXX
   161+XXXXXXX

Replace the 161 with your area code, if you live in an area with a 4 figure area code and a six figure number then lose an X and replace the 161 with your area code without the zero at the front

Hit the 'Submit' button

8. Repeat 6. and 7. for '1 teliax-out-route'

9. Select 'Trunks', then on the right hand side click on 'Trunk IAX2/teliax-out'

10. Type you phone number into the 'Outbound caller ID' box

11. Copy and Paste the following into the 'dial patterns' box:

    999
    0044|0+.
    00ZXXXXXXXXXX
    161+XXXXXXX

12. Copy the following into the 'PEER Details' box:

    allow=gsm
    auth=md5
    canreinvite=no
    context=from-pstn
    disallow=all
    host=gateway.tescointernetphone.com
    nat=yes
    qualify=60&no
    secret=XXXXXXXXXXXXXXX
    type=friend
    username=XXXXXXXXXXX

where the XXXX variables - secret = Password, username = your phone number

Hit the 'Submit' button

13. Hit the 'Apply configuration Changes' button at the top of the page. Accept the prompts to reload.

14. Select 'Phone Lines' from the Left side menu.

15. Click on the 'Activate Automatic Configuration' button. At the prompt 'Are you sure you want to activate automatic configuration?' click on the button 'Yes and Keep my Advanced settings'

Reload the router and the orbiters and you are finished.