Tesco Internet Phone

From LinuxMCE
Revision as of 05:20, 22 March 2009 by Techstyle (Talk | contribs)

Jump to: navigation, search

www.tescointernetphone.com

Manual Setup

The article describes setting up the Tesco Internet Phone from the 'Phone Lines' page of the Web Admin interface.

1. From the pull down menu select 'teliax'

2. Type in the Information requested:

  Username:       (this is your Tesco Internet Phone Number)
  Password:       (your Password)
  Phone Number:   (Your number, same as your username)
  Host:           gateway.tescointernetphone.com

Then hit 'submit'

3. Hit the 'Deactivate Automatic Configuration' button

4. The prompt says 'Are you sure you want to activate manual phone lines configuration?', hit the yes button

5. The prompt says 'Manual configuration activated. To configure AMP, click click here', hit the 'click here' link

6. Select 'Outbound Routes', on the right hand side click on '0 teliax-out-route'

7. Copy and Paste the following into the 'dial patterns' box:

   999
   0044|0+.
   00ZXXXXXXXXXX
   161+XXXXXXX

Hit the 'Submit' button

8. Repeat 6. and 7. for '1 teliax-out-route'

9. Select 'Trunks', then on the right hand side click on 'Trunk IAX2/teliax-out'

10. Type you phone number into the 'Outbound caller ID' box

11. Copy and Paste the following into the 'dial patterns' box:

    999
    0044|0+.
    00ZXXXXXXXXXX
    161+XXXXXXX

12. Copy the following into the 'PEER Details' box:

allow=gsm auth=md5 canreinvite=no context=from-pstn disallow=all host=gateway.tescointernetphone.com nat=yes qualify=60&no secret=XXXXXXXXXXXXXXX type=friend username=XXXXXXXXXXX

where the XXXX variables - secret = Password, username = your phone number

Hit the 'Submit' button

13. Hit the 'Apply configuration Changes' button at the top of the page. Accept the prompts to reload.

14. Select 'Phone Lines' from the Left side menu.

15. Click on the 'Activate Automatic Configuration' button. At the prompt 'Are you sure you want to activate automatic configuration?' click on the button 'Yes and Keep my Advanced settings'

Reload the router and the orbiters and you are finished.