Tricklestar 200ZW-EU-W

From LinuxMCE
Revision as of 08:34, 27 September 2012 by Hari (Talk | contribs)

(diff) ←Older revision | view current revision (diff) | Newer revision→ (diff)
Jump to: navigation, search
Version Status Date Updated Updated By
710 According to category, Works without caveats 11th May 2010 Wierdbeard65
810 According to category, Works without caveats 11th May 2010 Wierdbeard65
1004 Unknown N/A N/A
1204 Unknown N/A N/A
1404 Unknown N/A N/A
Usage Information
Tricklestar 200ZW-EU-W


Tested with the latest svn Z-Wave driver (will be included in 0810). Also works as inclusion controller when LinuxMCE runs as SIS. Runs also fine with stock 0710 as primary or secondary controller.

This is a recommended inclusion controller


The Tricklestar 200ZW-EU-W is a Z-Wave Remote Controller based on a Zensys chip. It uses a frequency of 868MHz. There is also a US version.

Configuration Switch

The product has a slide switch under the Rubber end piece (next to the USB connector), which can set the product in “Operation Mode” and “Configuration Mode”.

How to reset the Remote (from the Manual)

Resetting the Controller

  1. Put the Configuration Switch in “Configuration Mode”.
  2. Press-and-hold “Up” Operation button for 2 seconds to enter Configuration Mode. LED Indicator will illuminate Green.
  3. Press-and-hold “Up” Operation button for 10 seconds - this will initiate a reset of the Controller. LED Indicator will alternate Red, Yellow and Green while remote is being reset.
  4. LED Indicator on the Remote will illuminate Green when Reset is successfully completed and illuminate Red if the operation is unsuccessful.