Difference between revisions of "Wayne-Dalton Thermostat"
From LinuxMCE
| Line 3: | Line 3: | ||
[[Category: ZWave]] | [[Category: ZWave]] | ||
| + | [[Category: Hardware]] | ||
| + | [[Category: RF Control]] | ||
| + | [[Category: ZWave]] | ||
| − | [[Image:WAWDTC20_FULL.jpg| | + | [[Image:WAWDTC20_FULL.jpg|thumb|250px|Wayne-Dalton Zwave Thermostat]] |
| + | = Status = | ||
| + | Recognized by LMCE as a thermostat. Currently the buttons on the orbiter do not properly control the thermostat. Also there are no auto generated scenarios created for the home screen. | ||
| + | |||
| + | |||
| + | = About = | ||
| + | |||
| + | |||
| + | = Zwave Modes = | ||
| + | |||
| + | |||
| + | = How to set the Zwave mode = | ||
| + | |||
| + | Resetting the Controller | ||
| + | # Put the Configuration Switch in “Configuration Mode”. | ||
| + | # Press-and-hold “Up” Operation button for 2 seconds to enter Configuration Mode. LED Indicator will illuminate Green. | ||
| + | # Press-and-hold “Up” Operation button for 10 seconds - this will initiate a reset of the Controller. LED Indicator will alternate Red, Yellow and Green while remote is being reset. | ||
| + | # LED Indicator on the Remote will illuminate Green when Reset is successfully completed and illuminate Red if the operation is unsuccessful. | ||
| + | |||
| + | = Links = | ||
http://www.homecontrols.com/cgi-bin/main/co_disp/displ/prrfnbr/12155/sesent/00/Wayne-Dalton-Z-Wave-Thermostat | http://www.homecontrols.com/cgi-bin/main/co_disp/displ/prrfnbr/12155/sesent/00/Wayne-Dalton-Z-Wave-Thermostat | ||
http://forum.linuxmce.org/index.php?topic=5844.0 | http://forum.linuxmce.org/index.php?topic=5844.0 | ||
Revision as of 18:22, 4 March 2009
Status
Recognized by LMCE as a thermostat. Currently the buttons on the orbiter do not properly control the thermostat. Also there are no auto generated scenarios created for the home screen.
About
Zwave Modes
How to set the Zwave mode
Resetting the Controller
- Put the Configuration Switch in “Configuration Mode”.
- Press-and-hold “Up” Operation button for 2 seconds to enter Configuration Mode. LED Indicator will illuminate Green.
- Press-and-hold “Up” Operation button for 10 seconds - this will initiate a reset of the Controller. LED Indicator will alternate Red, Yellow and Green while remote is being reset.
- LED Indicator on the Remote will illuminate Green when Reset is successfully completed and illuminate Red if the operation is unsuccessful.
