Difference between revisions of "Merten 506004 Connect Radio Transmitter FM 4gang"
From LinuxMCE
(→Device setup) |
m (→Input setup) |
||
| Line 18: | Line 18: | ||
triple click on connected switch | triple click on connected switch | ||
== Input setup == | == Input setup == | ||
| − | <table border="1"><th>Input</th><th>Association Group</th><th>Parameter no</th> | + | <table border="1"><th>Input</th><th>Association Group</th><th>Parameter no</th><th>Wire pair</th> |
| − | <tr><td>1</td><td>1</td><td>0</td></tr> | + | <tr><td>1</td><td>1</td><td>0</td><td>red/white-red</td></tr> |
| − | <tr><td>2</td><td>2</td><td>1</td></tr> | + | <tr><td>2</td><td>2</td><td>1</td><td>green/white-green</td></tr> |
| − | <tr><td>3</td><td>3</td><td>2</td></tr> | + | <tr><td>3</td><td>3</td><td>2</td><td>brown/white-brown</td></tr> |
| − | <tr><td>4</td><td>4</td><td>3</td></tr> | + | <tr><td>4</td><td>4</td><td>3</td><td>blue/white-blue</td></tr> |
</table> | </table> | ||
| + | |||
== Parameter values == | == Parameter values == | ||
<table border="1"><th>Function</th><th>Value</th> | <table border="1"><th>Function</th><th>Value</th> | ||
Revision as of 23:27, 25 November 2008
Contents
Status
Working
About
The Merten 506004 is a 4gang Z-Wave battery powered remote controller that fits into a rocker box behind existing switches.
Features
- 4gang
- special door bell mode (not yet tested)
Device setup
Device type: Controller
Inclusion/Exclusion/Node Info Frame
triple click on connected switch
Input setup
| Input | Association Group | Parameter no | Wire pair |
|---|---|---|---|
| 1 | 1 | 0 | red/white-red |
| 2 | 2 | 1 | green/white-green |
| 3 | 3 | 2 | brown/white-brown |
| 4 | 4 | 3 | blue/white-blue |
Parameter values
| Function | Value |
|---|---|
|
Switching/Dimming/Shutters |
0 |
|
Switching single-surface |
4 |
|
Doorbell function |
44 |
|
Move shutter single surface (changes direction each press) |
54 |
|
Lower shutter as long as button is pressed |
52 |
|
Raise shutter as long as button is pressed |
55 |
Factory reset
- Press any button 3 times within 1.5 seconds. The LED will flash.
- Press and hold the button for about 5 seconds until the LED turns off.
Links
http://www.merten.de/download/DL_broschueren/DE_FunkSystem_CONNECT_494720.pdf
