Difference between revisions of "Access Point"

From LinuxMCE
Jump to: navigation, search
(New page: == My hardware setup == * Dell Optiplex Gx620 * WiFi card with Atheros chipset (using madwifi drivers) * Linux MCE 810 alpha2 == Overview == the idea is to combine or bridge eth1 and ...)
 
Line 1: Line 1:
 +
== Introduction ==
 +
 +
This tutorial describes how to add Access Point functionality to your LMCE core. The core will act as a WiFi access point permitting wireless devices
 +
 
== My hardware setup ==
 
== My hardware setup ==
  

Revision as of 06:41, 28 September 2009

Introduction

This tutorial describes how to add Access Point functionality to your LMCE core. The core will act as a WiFi access point permitting wireless devices

My hardware setup

  • Dell Optiplex Gx620
  • WiFi card with Atheros chipset (using madwifi drivers)
  • Linux MCE 810 alpha2

Overview

the idea is to combine or bridge eth1 and ath0 to a new virtual interface called br0.

  • -> eth0 connects to my ADSL modem (192.168.5.0)
  • -> eth1 connects to my internal LAN switch (192.168.80.0)
  • -> ath0 connects the wireless part of my internal network (192.168.80.0)

Needed packages

  • hostapd
  • bridge


Config files

/etc/network/interfaces


/etc/default/dhcp.conf

/etc/default/dhcpd3/dhcpd.conf

Enable WPA encryption

  • edit the /etc/hostapd

Set static IP adresses