Difference between revisions of "User:Apagg"

From LinuxMCE
Jump to: navigation, search
 
(4 intermediate revisions by 2 users not shown)
Line 1: Line 1:
 +
[[Category:User Setups]]
 +
[[Category:Climate]]
 +
[[Category:Zwave_Setups]]
 +
 
= My Setup =
 
= My Setup =
  
Line 6: Line 10:
 
*[[LSControl ES 861 Humidity]] Humidity sensor ''(eats battery's)''
 
*[[LSControl ES 861 Humidity]] Humidity sensor ''(eats battery's)''
 
*[[Everspring ST814]] Temp/hum sensor
 
*[[Everspring ST814]] Temp/hum sensor
*[[ACT Homepro ZDW230]] Dimmer wall
+
*[[ACT Homepro ZDW230]] Dimmer wall mounted
 +
*[[Düwi 05433]] Dimmer wall mounted
 
*[[ACT Homepro ZDP200]] Dimmer plugin
 
*[[ACT Homepro ZDP200]] Dimmer plugin
 
*[[ACT Homepro ZRP200]] Appliance module plugin
 
*[[ACT Homepro ZRP200]] Appliance module plugin
 +
*[[Düwi plug adaptor switch ZW ZS 3500]] Appliance module plugin
 
*[[Merten 507501]] Appliance module Flush-mounted
 
*[[Merten 507501]] Appliance module Flush-mounted
 
*[[Express Controls EZmotion]] Temp/Light/Motion sensor
 
*[[Express Controls EZmotion]] Temp/Light/Motion sensor
 
*[[ACT Homepro ZTH200]] Remote
 
*[[ACT Homepro ZTH200]] Remote
 +
*[[Tricklestar 200ZW-EU-W]] Remote
  
 
= Delayed event =
 
= Delayed event =

Latest revision as of 14:46, 18 August 2010


My Setup

Home Automation

Delayed event

To make a scenario for heating my care in the morning and by a climate scenario on the orbiter I have made the following setup.


This scenario turns on the wall outlet for the car and turns it off after 1,5 hours. If I execute this scenario form the orbiter it does not work it will just send all the commands at once and there will be no delay. So I hide this scenario by unchecking all the rooms.

Varm bil (skjult).png

I then made another scenario to execute this scenario:

Varm bil.png

I also added a Timed Event to execute this scenario every weekday morning.

Varm bil 2.png

Climate control

I have started my quest to control all heating in my house using LMCE. I am using Z-Wave as my primary control system. The temp sensors are LSControl ES 861 and the heaters are controlled by various Z-Wave modules.

The first room out is the bedroom. I only need to have this room warm when I go to bed and wake up. If I am not sleeping at home I don't need to turn the heat up at all (HouseMode = Extended-away). These two events control the heater. They are both Temperature Changed Events. The first event turns the heater on, the second turns it off.
Sov on.png Sov off.png