Difference between revisions of "Merten 5071xx Connect Radio Push Button 2gang"
From LinuxMCE
(New page: Category: Hardware Category: Lighting Automation Category: ZWave Merten 506004 = Status = Working = About = The Merten 5071xx is a 2ga...) |
|||
| Line 3: | Line 3: | ||
[[Category: ZWave]] | [[Category: ZWave]] | ||
| − | [[Image: | + | [[Image:Connect507146.jpg|thumb|200px|Merten 5071xx]] |
| + | |||
= Status = | = Status = | ||
Working | Working | ||
| Line 11: | Line 12: | ||
= Features = | = Features = | ||
| − | * | + | * 2gang |
* special door bell mode (not yet tested) | * special door bell mode (not yet tested) | ||
| Line 20: | Line 21: | ||
== Input setup == | == Input setup == | ||
| − | <table border="1" | + | <table border="1"><th>Button</th><th>Association Group</th><th>Parameter no</th> |
| − | <tr | + | <tr><td>Top</td><td>1</td><td>0</td></tr> |
| − | <tr | + | <tr><td>Bottom</td><td>2</td><td>1</td></tr> |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
</table> | </table> | ||
Revision as of 12:09, 23 December 2008
Contents
Status
Working
About
The Merten 5071xx is a 2gang Z-Wave battery powered remote controller that can be screwed or stuck to a surface.
Features
- 2gang
- special door bell mode (not yet tested)
Device setup
Device type: Controller
Inclusion/Exclusion/Node Info Frame
- triple click on connected switch
Input setup
| Button | Association Group | Parameter no |
|---|---|---|
| Top | 1 | 0 |
| Bottom | 2 | 1 |
Parameter values
| Function | Value |
|---|---|
|
Switching/Dimming/Shutters |
0 |
|
Switching single-surface |
4 |
|
Retrieve scene |
60 |
|
Doorbell function |
44 |
|
Move shutter single surface (changes direction each press) |
54 |
|
Lower shutter as long as button is pressed |
52 |
|
Raise shutter as long as button is pressed |
55 |
Factory reset
- Press button 3 times within 1.5 seconds. The LED will flash.
- Press and hold the button for about 5 seconds until the LED turns off.
