Difference between revisions of "Merten 5071xx Connect Radio Push Button 2gang"
From LinuxMCE
m |
|||
| Line 1: | Line 1: | ||
| − | [[Category: | + | [[Category: Automation]] |
[[Category: Lighting Automation]] | [[Category: Lighting Automation]] | ||
[[Category: ZWave]] | [[Category: ZWave]] | ||
Revision as of 01:42, 11 August 2009
Contents
Status
Working
About
The Merten 5071xx is a 2gang Z-Wave battery powered remote controller that can be screwed or stuck to a surface.
Features
- 2gang
- special door bell mode (not yet tested)
Device setup
Device type: Controller
Inclusion/Exclusion/Node Info Frame
- triple click on connected switch
Input setup
| Button | Association Group | Parameter no |
|---|---|---|
| Top | 1 | 0 |
| Bottom | 2 | 1 |
Parameter values
| Function | Value |
|---|---|
|
Switching/Dimming/Shutters |
0 |
|
Switching single-surface |
4 |
|
Retrieve scene |
60 |
|
Doorbell function |
44 |
|
Move shutter single surface (changes direction each press) |
54 |
|
Lower shutter as long as button is pressed |
52 |
|
Raise shutter as long as button is pressed |
55 |
Factory reset
- Press button 3 times within 1.5 seconds. The LED will flash.
- Press and hold the button for about 5 seconds until the LED turns off.
