Difference between revisions of "Danfoss RA Plus-w"
From LinuxMCE
(→Status) |
m |
||
| Line 1: | Line 1: | ||
| − | [[Category: | + | [[Category: Automation]] |
[[Category: Climate]] | [[Category: Climate]] | ||
[[Category: ZWave]] | [[Category: ZWave]] | ||
Revision as of 03:57, 11 August 2009
Contents
Status
initial support is included in the svn. Will be shipped in the next stable release (0810). Requires SIS mode for full plug and play operation (you need a recent Z-Wave portable controller that can work as inclusion controller in sis mode like the Tricklestar_200ZW-US-W).
About
RA-PLUS-w is a programmable radiatorthermostat, that gives the possiblity to decrease the room temperature with about 3 degrees in chosen periods of the day.
Features
- By decreasing the temperature in periods of the day the energy used for heating can be reduced without compromising on the comfort.
- The thermostat communicates through the wireless Z-Wave standard just like other devices.
- The thermostat is secured against frost.
Device setup
General information
- Supported wake up interval: 5 - 30 minutes
- Clock adjustement: every 30 minutes
Day/Night button
- 1x short press: toggle between comfort and setback operation
- 3x short press: network inclusion and exclusion
- 1x long press (5 seconds): link test
Reset button
Remove the motor unit with the two release buttons from the thermostat to access the reset button. It's aside the sticker on right.
- 1x press: factory reset, also resets home/node id
LED status feedback
- Fast blink: inclusion/exclusion/waiting for wakeup interval configuration
- LED is lit: link test
- Slow blink: operation failed
- Short flash every 15s: battery low
Notes
Remove the motor when changing batteries, the device won't detect the change otherwise.
