Difference between revisions of "ACT Homepro ZDW232"
From LinuxMCE
| Line 14: | Line 14: | ||
= Advanced Features = | = Advanced Features = | ||
* Night Light | * Night Light | ||
| − | * | + | ** Parameter No: 3 |
| + | ** Length: 1 Byte | ||
| + | ** Valid Values = 0 or 1 (default value is 0) | ||
| + | ** The LED on the ZDW232 will by default, turn ON when the load attached is turned ON. To make the LED turn ON when the load attached is turned OFF instead, set parameter 3 to a value of 1. | ||
| + | |||
| + | * Invert Switch | ||
| + | ** Parameter No: 4 | ||
| + | ** Length: 1 Byte | ||
| + | ** Valid Values = 0 or 1 (default value is 0) | ||
| + | ** To change the top of the switch to OFF and the bottom of the switch to ON, set parameter 4 to 1. | ||
| + | |||
* Adjusting Dim Rate | * Adjusting Dim Rate | ||
| + | = [[Tweaking advanced ZWave settings]] = | ||
= Caveats = | = Caveats = | ||
Revision as of 18:51, 28 June 2010
| Version | Status | Date Updated | Updated By |
|---|---|---|---|
| 710 | According to category, Works without caveats | 27th Jun 2010 | Valent |
| 810 | According to category, Works without caveats | 11th May 2010 | Valent |
| 1004 | Unknown | N/A | N/A |
| 1204 | Unknown | N/A | N/A |
| 1404 | Unknown | N/A | N/A |
| Usage Information | |||
Contents
Features
- The ZDW232 is a single dimming receiver which controls the connected load ON/OFF and DIM/BRIGHT and also serves as a transmitter using multiple switch taps (controls one group of 5 Z-Wave modules).
- ZDW232 replaces an existing wall switch.
- ZDW232 can be programmed as a routing slave to establish firm signal routes and can be "associated" with other Z-wave devices in order to control them.
- ZDW232 can be configured to Control Shades or Window Coverings via Z-Wave network.
Advanced Features
- Night Light
- Parameter No: 3
- Length: 1 Byte
- Valid Values = 0 or 1 (default value is 0)
- The LED on the ZDW232 will by default, turn ON when the load attached is turned ON. To make the LED turn ON when the load attached is turned OFF instead, set parameter 3 to a value of 1.
- Invert Switch
- Parameter No: 4
- Length: 1 Byte
- Valid Values = 0 or 1 (default value is 0)
- To change the top of the switch to OFF and the bottom of the switch to ON, set parameter 4 to 1.
- Adjusting Dim Rate
Tweaking advanced ZWave settings
Caveats
Do not connect regulat CFL bulbs to this switch because if they aren't special dimmable CFL bulbs.
About
This is the 2-wire version, there is also a 3-wire version (ZDW230) available.
