Difference between revisions of "Merten 5072xx Connect Radio Push Button 4gang"
From LinuxMCE
| Line 1: | Line 1: | ||
| + | [[Category: Hardware]] | ||
[[Category: Automation]] | [[Category: Automation]] | ||
[[Category: Lighting]] | [[Category: Lighting]] | ||
Latest revision as of 15:54, 28 September 2010
| Version | Status | Date Updated | Updated By |
|---|---|---|---|
| 710 | Unknown | N/A | N/A |
| 810 | Unknown | N/A | N/A |
| 1004 | Unknown | N/A | N/A |
| 1204 | Unknown | N/A | N/A |
| 1404 | Unknown | N/A | N/A |
| Usage Information | |||
Contents
Status
Working
About
The Merten 5072xx is a 2-surface, 4-gang Z-Wave battery powered remote controller that can be screwed or stuck to a surface.
Features
- dual surface, 4-gang
- special door bell mode (not yet tested)
Device setup
Device type: Controller
Inclusion/Exclusion/Node Info Frame
- triple click on connected switch
Input setup
| Button | Association Group | Parameter no |
|---|---|---|
| Top Left | 1 | 0 |
| Bottom Left | 2 | 1 |
| Top Right | 3 | 2 |
| Bottom Right | 4 | 3 |
Parameter values
| Function | Value |
|---|---|
|
Switching/Dimming/Shutters |
0 |
|
Switching single-surface |
4 |
|
Retrieve scene |
60 |
|
Doorbell function |
44 |
|
Move shutter single surface (changes direction each press) |
54 |
|
Lower shutter as long as button is pressed |
52 |
|
Raise shutter as long as button is pressed |
55 |
Factory reset
- Press button 3 times within 1.5 seconds. The LED will flash.
- Press and hold the button for about 5 seconds until the LED turns off.
