Difference between revisions of "EasyN FS-603A-M106 IP Camera"
From LinuxMCE
(→Setup) |
|||
Line 35: | Line 35: | ||
* Video stream URL: http://cameraIP:webserverport/videostream.cgi | * Video stream URL: http://cameraIP:webserverport/videostream.cgi | ||
− | * Followed IP Cameras wiki and it worked flawlessly | + | * Followed [[IP_Cameras|IP Cameras wiki]] and it worked flawlessly |
=Comment= | =Comment= |
Revision as of 12:49, 19 May 2012
Version | Status | Date Updated | Updated By |
---|---|---|---|
710 | Unknown | N/A | N/A |
810 | Working | 30 April 2011 | Jamo |
1004 | Unknown | N/A | N/A |
1204 | Unknown | N/A | N/A |
1404 | Unknown | N/A | N/A |
Usage Information |
Contents
Status
- The EasyN FS-603 works with video via wired network
- Could not get FS-603 to connect to my WPA-2 wi-fi access point. Not sure why - did not try with a non-protected accesspoint.
Features
- Browser based
- 10/100mbit LAN
- Wi-fi
- IR - day/night
- 30fps max
- Supports high speed hardware-based Motion-JPEG compression
- Supports video resoultion:640x480(VGA),320x240(CIF) and 160x120(QCIF)
- UPnP, DynDNS
- Real-Time Live Video
Installation notes
- technical issue - the camera has a thick cable that comes out of the back plate which then splits into various connectors - s-video, RCA, A reset switch, 12v supply socket and RJ-45 female port. I installed the camera on an external wall of the house and drilled a hole through the double-skin brick wall in order to push the cable through neatly.... problem was the cable (specifically because of the RJ-45 jack) would require a HUGE diameter hole to go through... probably around 40mm. That is a big hole to put in the wall of your house in order to neatly install a camera. I experimented with a number of options but ended up cutting the cable *gasp* and re-soldering and heat-shrinking the individual copper wires on the inside of the wall. Not a great solution but it was done neatly and it works.
- 12v power supply: the camera comes with a transformer to take 230v AC down to the 12V DC supply required by the camera. I had to install a 230V AC wall socket in my ceiling area in order to plug in the transformer.
- Wall bracket supplied is not particularly solid, nor or the wall plugs and screws to mount it. Be gentle and careful... it's easier to over-tighten and strip. So far it is still pointing in the right direction despite a few large storms.
EasyN FS-603 Camera and Motion Wrapper
IP cameras can be used under the Motion Wrapper to enable it to detect motion and alert based on that function. I haven't tested or experimented with this feature yet.
Setup
- Video stream URL: http://cameraIP:webserverport/videostream.cgi
- Followed IP Cameras wiki and it worked flawlessly
Comment
- Good for the price- about ZAR1600 delivered. Very cheap for IP camera
- Support / manual is horrendous - translation from mandarin or something and no website/forum/tech-support evident
- web-based setup works OK but lots of features that are probably intended for other models not supported by this one (switch on/off, zoom etc)
- On maunfacturer website (http://www.easynp.com) it appears product is old / discontinued
- Purchase source: http://www.securitycameras.co.za/shop/product_info.php?cPath=32&products_id=253