Merten 5071xx Connect Radio Push Button 2gang
From LinuxMCE
Revision as of 12:04, 23 December 2008 by DomoDude (Talk | contribs) (New page: Category: Hardware Category: Lighting Automation Category: ZWave Merten 506004 = Status = Working = About = The Merten 5071xx is a 2ga...)
Contents
Status
Working
About
The Merten 5071xx is a 2gang Z-Wave battery powered remote controller that can be screwed or stuck to a surface.
Features
- 4gang
- special door bell mode (not yet tested)
Device setup
Device type: Controller
Inclusion/Exclusion/Node Info Frame
- triple click on connected switch
Input setup
| Button Type | Button | Association Group | Parameter no |
|---|---|---|---|
| Single Surface | Top | 1 | 0 |
| Bottom | 2 | 1 | |
| Dual Surface | Top Left | 1 | 0 |
| Bottom Left | 2 | 1 | |
| Top Right | 3 | 2 | |
| Bottom Right | 4 | 3 |
Parameter values
| Function | Value |
|---|---|
|
Switching/Dimming/Shutters |
0 |
|
Switching single-surface |
4 |
|
Retrieve scene |
60 |
|
Doorbell function |
44 |
|
Move shutter single surface (changes direction each press) |
54 |
|
Lower shutter as long as button is pressed |
52 |
|
Raise shutter as long as button is pressed |
55 |
Factory reset
- Press button 3 times within 1.5 seconds. The LED will flash.
- Press and hold the button for about 5 seconds until the LED turns off.
