Revision as of 14:35, 26 July 2010

Danfoss RA-PLUS-w ZWave radiator thermostat

Status

initial support is included in the svn. Will be shipped in the next stable release (0810). Requires SIS mode for full plug and play operation (you need a recent Z-Wave portable controller that can work as inclusion controller in sis mode like the Tricklestar_200ZW-US-W).

About

RA-PLUS-w is a programmable ZWave radiator thermostat, that gives the possiblity to decrease the room temperature with about 3 degrees in chosen periods of the day.

Features

• By decreasing the temperature in periods of the day the energy used for heating can be reduced without compromising on the comfort.
• The thermostat communicates through the wireless Z-Wave standard just like other devices.
• The thermostat is secured against frost.

Device setup

General information

• Supported wake up interval: 5 - 30 minutes
• Clock adjustement: every 30 minutes

Day/Night button

• 1x short press: toggle between comfort and setback operation
• 3x short press: network inclusion and exclusion
• 1x long press (5 seconds): link test

Reset button

Remove the motor unit with the two release buttons from the thermostat to access the reset button. It's aside the sticker on right.

• 1x press: factory reset, also resets home/node id

LED status feedback

• Fast blink: inclusion/exclusion/waiting for wakeup interval configuration
• LED is lit: link test
• Slow blink: operation failed
• Short flash every 15s: battery low

Notes

Remove the motor when changing batteries, the device won't detect the change otherwise.

Links

Installation

Data Sheet

http://www.seluxit.com/Third%20Party.html

http://www.raplusw.com

http://raplusw.com/Content/e962fc0b-6461-4319-82fe-3e1e765142cf.html